Generalaire 570 SERIES Elite Instrukcja Użytkownika Pobierz pdf

570 SERIES

DOWN FLOW

RETURN AIR

WARM AIR

DRAIN

Connect by-pass pipe to collar and humidifier cabinet. Using

holes at top and bottom of side panel discharge, pierce 2

self tapping screws through by-pass pipe.

PRECAUTION: The installer should be an experienced service technician. Disconnect electrical power before

beginning installation. Do not install where temperatures fall below 32 degrees F or where plenum temperatures

exceed 150 degrees F. When wiring into a multi-speed blower circuit see Step 6.

FOR INSTALLATION ON A VERTICAL

PLENUM SURFACE OF ANY

FORCED AIR FURNACE

INSTALLER: PLEASE FILL OUT AND MAIL WARRANTY CARD AFTER INSTALLATION IS

COMPLETE. LEAVE INSTALLATION INSTRUCTIONS WITH HOME OWNER

INSTALLATION: The humidifier may be mounted with the 6" outlet to

the right or left by inverting the cabinet and reversing the positions of

the distributor trough and drain pan. The humidifier may be mounted

on the warm or return air plenum with equal efficiency.

See Typical Installations.

ADDITIONAL MATERIALS THAT MAY BE NECESSARY:

1. 1/4" diameter plastic supply tubing or 1/4" copper

supply tubing for hot water applications

2. 6" diameter galvanized by-pass pipe

3. electrical wire and wire nuts

4. current sensing relay (G.F. Model #GA50 suggested)

5. #8 self piercing sheet metal screws

FLOW-THROUGH

BYPASS HUMIDIFIER

COPPER

TUBING

PLASTIC

TUBING

Mount the self tapping saddle valve or code valve on either a cold

or a hot water pipe. A side or top mount is best to avoid clogging

from pipe sediment. Connect 1/4” O.D. tubing to the saddle valve.

Copper tubing requires a brass compression nut and brass sleeve.

Plastic tubing requires a brass insert inside the tubing, a plastic

sleeve on the outside with a brass compression nut.

NOTE: DO NOT USE PLASTIC TUBING ON HOT WATER OR IN

CONTACT WITH ANY HOT PLENUM SURFACE OR DUCT.

INSTALLATION OF THIS SADDLE VALVE MUST MEET OR

EXCEED LOCAL CODES AND ORDINANCES.

GENERALAire AC SERIES

HIGH EFFICIENCY AIR CLEANER

UP FLOW

RETURN AIR

WARM AIR

DRAIN

Fresh Indoor Air Quality

FORM NO. 570-18 REV. F

6”

9-1/2”

8-7/8”

The GeneralAire model 570 may be installed on either the

supply or return plenum of a forced air handling system. Select

a location for the humidifier that allows for service and

maintenance. Cut out a rectangle 8-7/8” wide by 9-1/2“ tall.

Extend horizontal centerline of cut out to the adjacent plenum.

Cut a 6” hole 10” to 15” from side of humidifier, on cabinet

centerline, using connecting collar as guide. The bypass is

reversible and can be mounted on the right or left side of the

humidifier.

Humidifier is self retaining. Slide top side in first, then slide

chassis down. Level chassis and install center screws. If

by-pass pipe installs to opposite side of chassis, bend clip on

chassis, remove side discharge, and reinstall discharge to

opposite side of chassis. Install remaining four corner screws.

READ AND SAVE THESE INSTRUCTIONS

1 2 3 4 5 6 ... 11 12

Podsumowanie treści

Strona 1 - 570 SERIES

570 SERIESDOWN FLOWRETURN AIRWARM AIRWARM AIRDRAIN33Connect by-pass pipe to collar and humidifier cabinet. Using holes at top and bottom of side pane

Strona 2 - 1/2” TEE

Le principe de fonctionnement de l’humidificateur est basé sur la façon la plus efficace et la plus économique d’évaporer l’eau dans l’air. L’humidifi

Strona 3 - CARE AND MAINTENANCE

Nº de modèleFaible (0,75 CAH)GPDMoyen (0,50 CAH) Élevé (0,30 CAH)Elite 5701274 m2/800 pi2111 m2/1200 pi2186 m2/2000 pi2Elite 90017104 m2/1115 pi2153 m

Strona 4 - HOW THE HUMIDIFIER WORKS

Renseignements sur le produit :Numéro de série : ____________________________________________________________Modèle : _______________________________

Strona 5

Connect 1/4" water supply tube to brass filter at inlet of solenoid. DO NOT USE PLASTIC TUBING IN CONTACT WITH ANY HOT PLENUM SURFACE OR DUCT.

Strona 6 - WARRANTY REGISTRATION

900-14 DRAIN PAN 900-11 DAMPER KNOB 900-28 DAMPER DISK 570-2 SIDE PANEL DISCHARGE 570-40 PAD RAIL GA-10 EV

Strona 7 - SÉRIE 570

The operating principle of the humidifier is based on the most efficient and economical means of evaporating water to the air. The humidifier uses on

Strona 8 - (1/2 po)

Model No.Loose (0.75 AC/H)GPDAverage (0.50 AC/H) Tight (0.30 AC/H)Elite 57012800 sq. ft.1200 sq. ft.2000 sq. ft.Elite 900171115 sq. ft.1650 sq. ft.280

Strona 9 - GARANTIE LIMITÉE

Product Information:Serial Number: _____________________________________________________________Model: _______________________________________________

Strona 10 - ASSISTANCE TECHNIQUE

SÉRIE 570DÉBIT D’AIR VERS LE BASRETOUR D’AIRAIR CHAUDAIR CHAUDDRAIN33Raccorder le tuyau de dérivation au collier et au boîtier de l’humidificateur. Vi

Strona 11 - (ÉTÉ) (HIVER)

Tourner le bouton du registre à la position hiver (ouvert). Ouvrir l’alimentation en eau et vérifier le fonctionnement de l’humidificateur

Strona 12 - ENREGISTREMENT DE LA GARANTIE

900-11 BOUTON DU REGISTRE900-28 DISQUE DU REGISTRE570-2 ÉVACUATION PANNEAU LATÉRAL570-40 RAIL DU TAMPONGA-10 TAMPON D’ÉVAPORATION900-15 GOULOTTE DU DI

Komentarze do niniejszej Instrukcji

Brak uwag

Generalaire 570 SERIES Elite Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Nawilżacze Generalaire 570 SERIES Elite. GeneralAire 570 SERIES Elite Manuel d'utilisation Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nawilżacze Generalaire 570 SERIES Elite